Gas fireplace service
Sweep & inspection
Caps & crowns
Flue relining
Masonry repairLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Fireplace Services Cost in Pasadena?
Fireplace services in Pasadena typically run $89 to $275 for a standard chimney sweep, $150 to $450 for a Level 2 inspection, and $350 to $2,800 for most repairs, depending on what’s wrong and how far it reaches. A full stainless liner install is the big-ticket item, usually $1,800 to $4,800 for a single-flue home. Every price below is an estimate for the Pasadena market in 2026 – the written estimate you get after we look at the chimney sets the final number.
Fireplace Services Cost Breakdown (2026)
Here’s what the work looks like in dollars, line by line. These numbers assume a typical single-story or two-story home in Pasadena with a masonry or prefab fireplace.
| Service | Typical Price Range | What Drives the Number |
|---|---|---|
| Standard chimney sweep (Level 1) | $89 – $275 | Flue size, creosote thickness, ease of roof access |
| Level 2 inspection (camera-assisted) | $150 – $450 | Number of flues, camera run length, roof access |
| Level 3 inspection (diagnostic) | $400 – $1,200+ | What has to be opened up to see the problem |
| Chimney cap (Gelco or Famco) | $150 – $450 | Single flue vs. multi-flue, custom sizing |
| Crown repair or rebuild | $350 – $1,600 | Crown size, crack extent, whether the crown is poured new |
| Flashing repair | $250 – $650 | Roof pitch, siding type, extent of the seal failure |
| HeatShield resurfacing | $750 – $2,200 | Linear feet of flue, severity of the tile damage |
| DuraFlex stainless liner installation | $1,800 – $4,800 | Flue length, diameter, insulation, irregular flue shape |
| Firebox and damper repair | $250 – $1,500 | Whether the damper is rebuilt or replaced with a top-seal unit |
| Masonry joint repointing | $400 – $1,800 | Linear feet of mortar joint, height above the roofline |
The number you get will almost always land inside one of those bands. Sweeps are the cheapest part of the chimney’s life; structural work is the expensive part. A few things push the figure toward the top of a range: a chimney that’s never been swept, a two-story roof line that takes more setup, a flue that’s out of square (clay tile flues are rarely perfectly round), and any repair that has to happen behind brick that needs to come out. Caps and crown work usually sit lower because the job is exterior and easy to reach once the ladder’s up.
What Affects Fireplace Services Pricing in Pasadena
- Creosote thickness in the flue. A light dusting sweeps out in a standard pass. Glazed, tar-like creosote from a season of smoldering fires takes more time and more careful handling, and it’s the most common reason a sweep quote creeps upward. Most Pasadena homes burning wood through the cooler months land somewhere in the middle.
- Roof access and pitch. A single-story ranch with a gentle roof is quick work. A steep pitch or a chimney set close to a valley means more setup time, and setup is a real part of the labor line.
- Flue shape and condition. Square, rectangular, and oval flues all fit a liner differently. Offset flues – where the flue jogs sideways inside the chimney – make a flexible liner the only option, and that’s why we work with DuraFlex to fit irregular flues that other outfits decline.
- Number of flues. A fireplace and a furnace flue sharing one chimney means two runs, two inspections, and sometimes two caps. That’s a line in the estimate, not a surprise.
- Exterior condition. Cracks in the crown, a missing cap, or failed flashing around the base of the chimney all let Pasadena’s heavy Gulf-coast rain into the masonry. Fixing water entry early is the cheapest work you’ll ever do on a chimney.
- Material specification. Cheap liners cost less up front and cost more later. We specify professional-grade parts – HeatShield for resurfacing, DuraFlex for relining, Gelco and Famco for caps and covers, and Olympia Chimney and Copperfield components where they fit the job – so the number reflects the same materials a chimney professional would put on their own house.
How to Save on Fireplace Services
The biggest money saver on a chimney is catching a problem while it’s small. Here are the moves that actually pay off:
- Get a sweep and a Level 2 inspection together. Doing both in one visit is almost always cheaper than booking them separately, because half the setup is already done.
- Sweep once a season if you burn wood regularly. An annual sweep keeps creosote from building to the point where it needs slow, careful removal – and it protects the flue tile from damage.
- Fix the cap before winter. A missing cap lets rain, birds, and debris into a flue that’s otherwise fine. A Gelco or Famco cap is one of the lower-cost items on the table and prevents repairs that cost several times more.
- Ask about HeatShield before a full reline. When the flue tile is damaged but the chimney is otherwise sound, HeatShield resurfacing can restore the flue without cutting in a full stainless liner. Sometimes it’s the right call; sometimes a liner is. We’ll tell you which – and why.
- Book the estimate as a free visit. Every estimate from Remington is free, so there’s no reason to guess at a number before you have one in writing. Call (833) 334-7488 to set it up.
How Much Does a Chimney Sweep Cost in Pasadena?
A standard sweep in Pasadena runs $89 to $275. The lower end covers a single-flue fireplace with light buildup; the higher end covers a larger flue, heavier creosote, or a more involved roof setup. A sweep is not the same as an inspection – it cleans, it doesn’t diagnose – and a sweep plus a Level 2 inspection in one visit is the better value if you don’t have a recent inspection on record.
How Much Does a Level 2 Inspection Cost?
A Level 2 inspection in Pasadena typically costs $150 to $450, and it’s the inspection most home sales and most post-storm checks call for. It goes beyond the basic view – camera-assisted, covering the flue interior, the firebox, the crown, the cap, and the flashing. If your last inspection was years ago, or you’ve never had one, this is the one to book. Call (833) 334-7488 for a free estimate on the inspection visit.
Is It Cheaper to Repair or Replace My Liner?
Repair is usually cheaper than replacement when the damage is confined to the flue surface: HeatShield resurfacing runs $750 to $2,200 and restores the tile without a full reline. A full DuraFlex stainless liner runs $1,800 to $4,800 and is the right answer when the flue is cracked through, oversized for the appliance, or out of shape enough that resurfacing won’t hold. The honest call depends on what the camera sees, and we’ll show you what we’re looking at.
Does a Chimney Cap or Crown Repair Really Cost That Much?
Caps run $150 to $450 and crown repair or rebuild runs $350 to $1,600. Both are exterior work, done from the roof, and both protect the chimney interior from Pasadena’s rain. A crown that’s cracked and letting water into the masonry behind the brick is a small fix that prevents a large one. If it’s been years since anyone looked at the top of your chimney, that visit is worth the estimate.
Can You Come Today?
Often, yes. Same-day service is available for sweeps, inspections, and most repair estimates, depending on the day’s schedule. We answer 24/7 at (833) 334-7488, and fast dispatch from 7am to 7pm gets a technician out to look at the chimney and write the estimate on site. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Why Choose Remington Chimney Sweep for Fireplace Services in Pasadena?
Your chimney, start to finish: sweep, repair, and inspection handled by one company, so you’re not coordinating three contractors for one problem. We specify professional-grade materials on every job – DuraFlex for relining, HeatShield for resurfacing, Gelco and Famco for caps and covers, and Olympia Chimney and Copperfield parts where the job calls for them. These are the same materials chimney professionals specify nationwide, and using them is why a repair we do holds up instead of coming back a few seasons later.
One company, every part of the chimney. We diagnose the whole system – flue, firebox, damper, crown, cap, and flashing – in one visit and quote the whole job together. That’s the difference between a patch and a plan. Our technicians have up to 14 years of experience, and our estimates are always free and in writing. Learn more about our Remington Chimney Sweep services and the full scope of what we handle.
If you’re in the Pasadena area and your fireplace has been sitting cold through the summer, or you’ve noticed a draft, a smell, or water staining around the firebox, that’s the right time to get it looked at – not when you’re trying to light the first fire of the season. Call (833) 334-7488 and we’ll get an estimate on the calendar.
FAQs – Fireplace Services Cost
How much does a chimney sweep cost in Pasadena, TX?
A standard chimney sweep in Pasadena runs $89 to $275. The exact figure depends on flue size, creosote buildup, and roof access. Call (833) 334-7488 for a free estimate – estimates are free and the written quote sets the final price.
How much does a chimney inspection cost in Pasadena, TX?
A Level 2 inspection in Pasadena typically costs $150 to $450, and a Level 3 diagnostic inspection runs $400 to $1,200 or more depending on what has to be opened up. Pairing the inspection with a sweep in the same visit is the better value. Call (833) 334-7488 to schedule.
How much does it cost to reline a chimney in Pasadena, TX?
A full stainless liner installation in Pasadena typically runs $1,800 to $4,800. Flue length, liner diameter, insulation, and whether the flue is round or some other shape all move the number. Irregular flues take a flexible system like DuraFlex. Call (833) 334-7488 for a free estimate.
Can I get away with resurfacing instead of relining my chimney?
Sometimes yes – HeatShield resurfacing runs $750 to $2,200 versus $1,800 to $4,800 for a full reline. It works when the damage is surface-level and the tile is still structurally sound behind it. The camera tells the truth, and so will we: if resurfacing won’t hold, we’ll say so. Call (833) 334-7488 for a free estimate.
How much does a chimney cap cost in Pasadena, TX?
A chimney cap in Pasadena typically costs $150 to $450, with Gelco and Famco caps available to fit single-flue and multi-flue chimneys. It’s one of the least expensive items on the list and protects the flue from rain and debris. Call (833) 334-7488 for a free estimate.
Should I repair or replace my chimney crown?
Repair if the crack is small and the crown is otherwise intact; rebuild if the crown has separated from the chimney or is crumbling in more than one spot. Crown work runs $350 to $1,600. Either way, getting it done before the next heavy rain is what protects the chimney interior. Call (833) 334-7488 to get an honest look at it.
Do you charge extra for same-day service?
No. The price is set per job by the written estimate, and same-day scheduling doesn’t change the quote. We answer 24/7 at (833) 334-7488, with fast dispatch from 7am to 7pm, Sunday through Friday.
Get Your Free Estimate Today
Chimney costs in Pasadena come down to what your chimney actually needs, and the only way to know that is to look. Our estimates are free, our pricing is upfront, and we’ll tell you what your chimney needs – and what it doesn’t. Call (833) 334-7488 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Pasadena market as of 2026. Remington Chimney Sweep offers free estimates – call (833) 334-7488.
Written by the team at Remington Chimney Sweep.
What Our Customers Say
"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
- Karen Chen"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
- Elena Hernandez"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
- Matt Sutton